Way to Installing Wooden Railing for Staircase

0

Wooden Railing For Staircase – The stairs are common fixtures in many homes, and a suitable handrail is necessary for safety. You can install a wooden railing resistant materials available in most centers, home improvement. Determine the location of the banister on the wall. Standard railing height is 90 cm to 1.2 m (3-4 ft) above the stairs and running on the same angle. Measure a point upstream of the wall of one of the underpasses, then one point of one of the upper steps.

Use a stud finder to find the location of wall studs along the chalk line. Do everything possible for brands such as near the center of each stud as possible. Place the lower support wooden railing for staircase first. Place support more than one brand of asparagus. Use a small screwdriver or drill punch small marks on the drywall to indicate where the holes. Pilot holes through the drywall and studs so the bracket can be mounted on the wall. Make the holes with a 3 mm (1/8 inch) drill bit, drilling them directly on the wall without any angle. Connect the brackets to the wall with 5 cm (2 inch) screw finish, using a screwdriver or drill loaded with a clamping element.

Measure and cut lengths of rail to fit the wall with sufficient overlap to reach beyond the wall brackets for fewbout 7.5 cm (3 inches). Use a circular saw to make cuts or miter. Sharp or rough edges using sandpaper sand medium grain. Place the rail on the brackets and test the fit. Mark the location of the holes in the brackets to the bottom of the wooden railing for staircase. Remove the rail. Drill pilot holes about 2.5 cm (1 inch) deep into the wood. Replace the rail on the brackets. Insert 3.1 cm (1 1/4 inch) bolts through the brackets and even wood. Use a drill to secure them firmly together. Check the connection of rail to the slightly pulling the wooden wall.

Leave A Reply